Flexible planar supercapacitors by straightforward filtration and laser processing steps

There is ever increasing demand for flexible energy storage devices due to the development of wearable electronics and other small electronic devices. The electrode flexibility is best provided by a special set of nanomaterials, but the required methodology typically consists of multiple steps and are designed just for the specific materials. Here, a facile and scalable method of making flexible and mechanically robust planar supercapacitors with interdigital electrode structure made of commercial carbon nanomaterials and silver nanowires is presented. The capacitor structure is achieved with vacuum filtration through a micropatterned contact mask and finished with simple laser processing steps. A maximum specific capacitance of 4 F cm−3 was measured with cyclic voltammetry at scan rate of 5 mV s−1. The reliability and charge transfer properties of devices were further investigated with galvanostatic charge-discharge measurements and electrochemical impedance spectroscopy, respectively. Furthermore, mechanical bending tests confirmed the devices have excellent mechanical integrity, and the deformations have no adverse effects on the electrochemical charge-discharge behavior and stability.

Authors:
Pitkänen Olli, Eraslan Toprak, Sebök Dániel, Szenti Imre, Kukovecz Ákos, Vajtai Robert, Kordas Krisztian

Publication type:
A1 Journal article – refereed

Place of publication:

Keywords:
carbon nanotubes, laser processing, reduced graphene oxide, silver nanowires, supercapacitors, vacuum filtration

Published:

Full citation:
Olli Pitkänen et al 2020 Nanotechnology 31 495403

DOI:
https://doi.org/10.1088/1361-6528/abb336

Read the publication here:
http://urn.fi/urn:nbn:fi-fe2020110989667